Power Electronics
Sensored Brushless Motor Controller (ESC)
A three-phase brushless DC motor controller with Hall sensor feedback, designed for a 36 V bus. A dedicated half-bridge gate driver per phase, bootstrap-supplied high-side drive and wide phase traces were used.

The board was designed to drive a brushless DC motor fed from a 36 V battery line, using Hall sensor feedback. The power stage, gate drivers, controller and user interface share one two-layer board. The high-current phase traces and MOSFETs sit along the top edge; the controller and logic circuitry are grouped in the lower section.
Architecture
- Power stage
- A three-phase bridge built from three half-bridges, with two IRF3205 N-channel MOSFETs per phase.
- Gate drivers
- One IR2103S half-bridge driver per phase. The high-side MOSFETs are driven through a bootstrap circuit (diode and 220 nF capacitor); the drivers run from a 12 V rail.
- Controller
- STM32F401RCT6 (LQFP64) with a 25 MHz main crystal, a 32.768 kHz RTC crystal and 32 Mbit SPI flash (W25Q32).
- Feedback and input
- Three Hall sensor inputs, a potentiometer input for the throttle and four user buttons.
- Power distribution
- A 12 V rail for the gate drivers and 5 V and 3.3 V rails for the logic are derived from the 36 V bus.
- Interfaces
- USB-C connection and an I²C line for a 2×16 character LCD.
Let's talk about your project
Tell us about your hardware need or R&D idea, and we will clarify the scope and the steps together.




